понедельник, 10 июня 2013 г.

NWCR 01


Купил новый радиатор на проц, не посмотрел размеры теперь системник не закрыть. Придётся пилить фигурный вырез на крышке корпуса. 

2 комментария:

  1. Casino Finder (Google Play) Reviews & Demos - Go
    Check Casino Finder (Google Play). A look at some of worrione the best gambling sites in the world. filmfileeurope.com They offer wooricasinos.info a gri-go.com full https://septcasino.com/review/merit-casino/ game library,

    ОтветитьУдалить
  2. This is obvious in an element that’s meant to lie flat but leaves a gap when laid on a flat floor. The entrance half of Shower Curtains the mildew, known as the mildew cavity, is mounted to a stationary platen and aligns with the nozzle of the injection unit. The rear half of the mildew, known as the mildew core, is mounted to a movable platen, which slides alongside the tie bars. After the required cooling time, the mildew is then opened by the clamping motor. An ejection system, which is attached to the rear half of the mildew, is actuated by the ejector bar and pushes the solidified part out of the open cavity. Understanding the complexities of injection molding circulate and solidification is a little more} difficult as comparability with} those events in extrusion.

    ОтветитьУдалить